Thursday, August 20, 2009

Additive Views vs. Subtractive Views

Common Problem: When I place an electrical fixture or other family category it pops up automatically in other views I would rather not see it in.

Reason: In the default Revit tempate almost every category is unnecessarily turned on in all views so the same family shows up everywhere.

Solution: Create Additive Views instead of Subtractive Views for family categories that are only used in one or two views. By that I mean, start with most family categories turned off in your new view's visibility/graphics and gradually add the categories that you want to see.

Extra Tip: If you want future new views to be additive by default, create a view template. Then, when you apply the template to a view, check the option that reads "Apply automatically to new views of the same type."

1 comment:

Navya said...

Thanks for sharing..
CAD conversion
Orthophotography services